khx1600c9d3k2/8g 8gb (4gb 512m x 64-bit x 2 pcs.) ddr3-1600 cl9 240-pin dimm kit description kingston's khx1600c9d3k2/8g is a kit of two 512m x 64-bit (4gb) ddr3-1600 cl9 sdram (synchronous dram), 2rx8 memory modules, based on sixteen 256m x 8-bit fbga compo- nents per module. total kit capacity is 8gb. each module kit has been tested to run at ddr3-1600 at a low latency timing of 9-9-9-27 at 1.65v.the spd's are programmed to jedec standard latency ddr3-1333 timing of 9-9-9. this 240-pin dimm uses gold contact fingers. the jedec electrical and mechanical specifications are as follows: document no. 4805928-001.d00 12/18/12 page 1 specifications cl(idd) 9 cycles row cycle time (trcmin) 49.5ns (min.) refresh to active/refresh 160ns (min.) command time (trfcmin) row active time (trasmin) 36ns (min.) maximum operating power 2.400 w* (per module) ul rating 94 v - 0 operating temperature 0 o c to 85 o c storage temperature -55 o c to +100 o c *power will vary depending on the sdram used. features ? jedec standard 1.5v (1.425v ~ 1.575v) power supply ? vddq = 1.5v (1.425v ~ 1.575v) ? 667mhz fck for 1333mb/sec/pin ? 8 independent internal bank ? programmable cas latency: 9, 8, 7, 6 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? programmable cas write latency(cwl) = 7 (ddr3-1333) ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write [either on the fly using a12 or mrs] ? bi-directional differential data strobe ? internal(self) calibration : internal self calibration through zq pin (rzq : 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95c ? asynchronous reset ? pcb : height 1.180? (30.00mm), double sided component memory module speci cations continued >> http://www..net/ datasheet pdf - http://www..net/
module dimensions document no. 4805928-001.d00 page 2 module with heat spreader continued hyperx all kingston products are tested to meet our published specifications. some motherboards or system configurations may not opera te at the published hyperx memory speeds and timing settings. kingston does not recommend that any user attempt to run their computer s faster than the published speed. overclocking or modifying your system timing may result in damage to computer components. for more information, go to www.kingston.com
http://www..net/ datasheet pdf - http://www..net/
|
